Pressure gauge add on

Membrane Flush kit
September 5, 2016
1 Micron Carbon Block
September 5, 2016
Show all

Pressure gauge add on

$13.95


One of the most important factors in the operation of your RO/DI system is pressure. Running…MPN#16204#

SKU: SKU16204. Categories: , .
Description
Product Details

One of the most important factors in the operation of your RO/ DI system is pressure. Running an RO system at too little pressure causes under production and over waste. Not to mention the fact that the membrane is unable to operate correctly and the output water will be higher in TDS. You use a TDS meter to test the quality of the output water but do you know the pressure your system is running under? You could be throwing away DI after DI simply because your RO is not working as well as it should. This is the next step in knowing exactly what is going on with your system! Installation is a snap with all Quick connect fittings included. With this purchase you will receive all the fittings needed to install your new gauge and a 500 foot roll of teflon tape…Just incase 🙂
Product Specifications

Gauge reads up to one hundred PSI and has a back/center 1/4 inch male thread inlet. All fittings are included with this purchase to install the valve either to a panel or loosely.
Whats Included?

1) 100 PSI RO Pressure Gauge
1) 1/4 tube by 1/4 female thread stem
1) 1/4×1/4×1/4 Y style T fitting
1) teflon tape
Additional Information
Weight 1 lbs
Dimensions 1 x 4 x 4 in